FSX Accelleration Mission "Bambibucket Training" created by jens.laimgruber@tmo.at with FSX ObjectPlacementTool Installation: Copy the Mission in the Mission folder "Tutorial". Copy the "Bambibucket_2" and "Waterdrop" into the FSX "Misc" folder. Copy the Bambitraining_rewards.RWD into the FSX "Reward" folder ************************************************************************* To prepare the Bell 206B Jetranger with a sling edit the aircraft.cfg and copy the following lines into it [Sling.0] hoist_extend_rate = 3 //Feet per second hoist_retract_rate = -3 //Feet per second position = 1.84, -4.14, 2.49 //Feet from datum max_stretch = 2.0 //Max stretch distance at ultimate load damping_ratio = 0.6 //0 for no damping to 1.0 for critically damped. rated_load = 507 //Characteristics tension of cable in pounds ultimate_load = 660 //Breaking force in pounds tolerance_angle = 45 //Angle, in degrees, used to determine lateral breaking force limit auto_pickup_range = 8 //Max Range, in feet, for auto-pickup auto_pickup_max_speed = 8.5 //Maximum speed (feet per second) for auto-pickup hoist_payload_station = 4 //Payload station in which the hoist will load in and out of. 1 is first station. hoist_door = 3 //Door associated with hoist. Must be open for use. [Sling.1] position = 0.0, 0.0, 0.0 //Feet from datum max_stretch = 2.0 //Max stretch distance at ultimate load damping_ratio = 0.75 //0 for no damping to 1.0 for critically damped. rated_load = 507 //Characteristics tension of cable in pounds ultimate_load = 1000 //Breaking force in pounds tolerance_angle = 70 //Angle, in degrees, used to determine lateral breaking force limit auto_pickup_range = 12 //Max Range, in feet, for auto-pickup auto_pickup_max_speed = 10 //Maximum speed (feet per second) for auto-pickup **************************************************************************** Enjoy this mission and have Fun!