FS2004 - photoreal panel Boeing 757-200 with wingviews and TCAS (optionally)
                made for Project Opensky B757-200 model.


Important!	This upload contains 2 modifications:

		A) panel with full internal views incl. 2 animated wingviews for the
                                     wingviews-model of POSKY B757-200, and can used for any 
                                     other B757/767, but you will not have "wingviews".
                                     (panel.zip)

                               B) alternative 2D-panel (no wingviews) for the virtual-cockpit-model
                                    of POSKY B757-200. For this you need to install from POSKY (not contained herein)
                                    the VC-model, VC-panel and the textures for the virtual cockpit
                                    into each livery which shall show the vitual cockpit.
		    (VC-panel.zip)

Each of both panel.zips contain an additionally file named "TCAS-panel.cfg", which appears in the panel-folder.
If you want to use TCAS, you need to install TCAS II V7.0 from Lee Hetherington into FS 2004 (not contained herein)

The upload contains 4 different panel.cfg's. When you will use the TCAS-panel.cfg, backup the file
panel.cfg, then delete it from the panel-folder and rename TCAS-panel.cfg to panel.cfg (don't forget this)


Installation: 	unzip the correspondig panel.zip into the panel-folder of your aircraft
                                 
                                If not already available, make first a second panel folder named "panel.vc", unzip version B)
                                into this folder and design this in the panel-section of the aircraft.cfg


Engine-starters are in the overhead-panel. Prior you need to switch-on the fuel-pumps left and right
below the marking "C-PUMPS".  The "OFF" signs will disappear.

The entry for "RADIOS" in your aircraft.cfg should read as follows:

[Radios]
// Radio Type = availiable, standby frequency, has glide slope
Audio.1       = 1
Com.1         = 1, 0
Com.2         = 1, 1
Nav.1         = 1, 0, 1
Nav.2         = 1, 0, 0
Adf.1         = 1
Transponder.1 = 1
Marker.1      = 1


What is from me: Only the bitmaps and the panel-arrangement (the VC-panel part is Posky original)

CREDIT therfore goes to all gauge-designers and to Posky for their excellent aircraft and VC-panel.


Good flights and safe landings !


Horst Paetzold


horstcloudflyer@aol.com