This repaint is designed to be used with Manfred Jahns' and company's FSX native, P3D(1-4) C-97 package. This repaint is NOT for FS2004 models. The Boeing C-97 or 377 Stratocruiser as it was also known is a gigantic radial engine transport that served as a military transport as well as a civilian airliner from the late 1940s into the 1960s. After their service was up, many sat around in the western US boneyards until eyes fell on them to become fire bombing airtankers. hawkins & Powers acquired some to turn into airtankers. Which turned out to be a labor intensive process. T-97 was a second chance airtanker, it previously was T-84. It had a massive for it's time 4,000 gallon tank installed in the belly. Making it by far, the largest air tanker in service. Even by today's standards it's still large. This however, led to it's likely downfall. It's shear size at the time limited it's use. Only being used on a few fires in Alaska and other areas in the western US and the Yellowstone Fire Storm in 1988 were it's only notable uses before it's eventual demise. It now sits at Hawkins & Powers' Museum in Greybull, WY. Repaint by: Nicholas Mitchell.

FSX/P3D Airbus A330-200 MEA (Middle East Airlines) Package. Middle east Airlines is the national carrier of the Lebanon and based at Beirut–Rafic Hariri International Airport. As of January 2020, Onur fly 5 A330-200 to destinations around Europe, the Middle East, Asia and Africa. Model by Thomas Ruth. Added the better Thomas Ruth modified VC with latest updates by Francois Dore, Bjoern Kesten. Fixed contact points. Added wing views and better VC. Includes built in FMC by Garret Smith. FMC will display in VC. Includes A330 manual. Custom A330 sounds and checklist included. FSX : requires either FSX Acceleration or Service packs 1 & 2. Used the textures by Mathieu Vos. Assembled and tested for P3Dv4.5 by Chris Evans Should also be fine in FSX and earlier P3D versions.

The A2D-1 was developed as a turboprop replacement for the iconic AD Skyraider series in the late 1940s. It was somewhat larger, faster and could carry a heavier weapons load. Unfortunately, the Allison T-40 series turboprop ran into many development delays mostly regarding reliability of the gear box which prevented the Sky Shark from being ordered into full production. It was the end of the line for prop driven attack aircraft for the US Navy. This is a major panel update for my previous FSX update to make the interior and panel look a lot more realistic. In addition to the three original textures by Paul Clawson there are two new "what-if" repaints based on textures by Juan Anotnio Martinez Castro, which he had designed for the FS2002 model by Kazunori Ito. The package also features exhaust smoke, better props and better reticule. Original native FSX model by Paul Clawson and 2D panel by Kazunori Ito. Two new repaints, new comletely reworked VC as well as new gauge configuration by Michael Pook. The model may work in FS2004 and P3D (v.3).

FSX/P3D Airbus A319-100 United Airlines Package. United is the world's 3rd largest airline and currently flies 81 A319-100 with a further 25 on order. The A318 is the smallest member of the A320 family and is capable of steep approach and short runway operations. Includes enhanced Thomas Ruth VC with updates by Louis Quintero and some further edits by Chris Evans (FSX : Go to Views -Instrument Panel. P3D: Go to Vehicle - Instrument panel), Custom CFM sounds. Also added jetway configs (Ctrl J). Model by Project Airbus. Added the great textures by Daniel Alamilla. Assembled for FSX/FSX Steam/P3D by Chris Evans

This is an update of the Alphasim HP Victor for FSX. I have added all the wheels; given it a 2D panel; I decreased the width of the left window strut on the 2D panel, so you have a bit better view to the left; added a hud to the VC; corrected the contact points; and updated the flight dynamics. It has the range it is supposed to, and cruises at mach 0.96. I did a previous update of the aircraft, but I believe it was the one made for FS9 not the one made for FSX. This is the whole aircraft.

FS2004/FSX Albatross DIII Development of the prototype D.III started in late July or early August 1916. Following the successful Albatros D.I and D.II series, the D.III utilized the same semi-monocoque, plywood-skinned fuselage. but adopted a sesquiplane wing arrangement broadly similar to the French Nieuport 11. The upper wingspan was extended, while the lower wing was redesigned with reduced chord and a single main spar. "V" shaped interplane struts replaced the previous parallel struts. GMAX mdl by A.F.Scrub.

This is the late model of the inter war Amiot medium bomber, which was used by the French airforce in the early days of WWII. The Amiot 143M entered service in July 1935, with deliveries continuing in 1936 and 1937. About six were going to be delivered to the Spanish Republican Air Force at the beginning of the Spanish Civil War. There is no evidence, however, that these obsolete French bombers flew over Spain during the Civil War. This is an FSX update with new and much more realistic panels. Original model by Paul Clawson, modified for FS2004 by Shessie of SOH. Exhaust smoke added. New virtual cockpit, new 2D panel and exhaust smoke configuration by Michael Pook. The model may work in FS2004 and P3D(Version3)

FSX/Accel/FS2004/P3dV3 Oceanliner TS Hanseatic. This fast and luxury vessel with steam turbines went in Pacific service in 1930 as Empress of Japan. During WWII the ship was renamed to Empress of Scotland, now used for troup transportation, still with three furrels. After 1958 she was totaly renewed for the German Hamburg-Atlantic Line, now with an almost double passenger capacity and a swimming pool instad of the third furrel and the new name TS Hanseatic. In 1966 in the New York harbour a great fire destroyed almost the complete interior so the vessel was wrecked later in Hamburg. Twenty nine camera views let you explore the decks and the virtual navigation bridge. In FSX you even can enjoy the support of the offshore tugboat Oceanic in VC-mode. The ai-model is supposed to be used with the great tool aicarriers2 or for ai-traffic. FSDS-model and camera- and effect configuration by Erwin Welker.

The Curtiss A-12 Shrike was a radial-engined derivative of the A-8, which was the first monoplane attack aircraft to serve in substantial numbers with the US Army Air Corps. It was the main aircraft of Army attack aviation strength throughout the early to mid-1930s. However the A-12 was rapidly made obsolescent by advances in aviation technology and its service with front-line units of the Army Air Corps was quite brief. By the late 1930s, it had been relegated largely to training units. Except for 20 export versions which were sent to China, the A-12 took no part in aerial combat during World War 2. This package is an FSX update for the FS9 version by Shessie and his team of SOH. It features an entirely new virtual cockpit and 2D panel. The original version was designed by David Wooster and his team and this model is also partly based on the FSX version by Paul Clawson. All credits go to the designers mentioned above. New panels and smoke effect by Michael Pook. The model may work in FS2004 and P3D (version3).

FSX/P3D Airbus A330-200 Jet2 Package. UK leisure airline Jet2 currently operate 2 A330-200. Model by Thomas Ruth. Added the better Thomas Ruth modified VC with latest updates by Francois Dore, Bjoern Kesten . Fixed contact points. Added wing views and better VC. Includes built in FMC by Garret Smith. Textures by Max Schloegl. FMC will display in VC. Includes A330 manual. Custom A330 sounds and checklist included. FSX : requires either FSX Acceleration or Service packs 1 & 2. Assembled and tested for P3Dv4.5 by Chris Evans Should also be fine in FSX and earlier P3D versions.