FSX/P3D Boeing 737 Max 8 Icelandair n/c blue package with Max VC. Icelandair is based at Keflavik International Airport and currently have 8 Boeing 737 Max 8 with another 2 on order. This is the new 2022 Icelandair livery. The high spec Boeing 737-Max 8 and paintkit from TDS. Credits go to TDS fantastic native FSX Boeing Max8 model and paintkit. The VC is the Microsoft/Alejandro Rojas Lucena/FSND base modified by Speedbird77 to resemble a Max cockpit, including gauges by G. Munro. There are custom CFM eco sounds included for that extra realism. Use - Instrument panel - Util for ground vehicles, doors stairs, fuel truck, buses. New Utility allows Bus, fuel, doors and more. (Go to Views - Instrument panel - Utility). VC added and edited to allow correct VC views, correct jetways and wheel levels. I added PDF B737 checklist. Textured, packaged and prepared for FSX & P3D up to v5 by Chris Evans.

This package is for use with the payware Nemeth/MilViz CH-47D. The pack includes 8 firefighting liveries as well as 4 internal tank/snorkel options and a 2,000 gallon bambi bucket assets for attachment using Lorby's FireFighterX application. The CH-47 Chinook, or Boeing 234 has been used in aerial firefighting for decades. However, recently surplus airframes are being retrofitted with internal tank systems similar to those found in fixed wing counterparts. Eliminating some of the hazards/restrictions associated with the use of bambi buckets. In addition, most of the internal tanking systems range from 2,500-3,000 US gallons of water or retardant. Greatly increasing the amount that can be dropped by these large helicopters. This package includes liveries for the following operators; Billings Flying Service, California Army National Guard, Columbia Helicopters, Coulson-Unical, Helimax Aviation, and Helifor. Repaints are compatible in both FSX and P3D, but the tank and bucket assets are only compatible in P3Dv4+. Lorby SI FireFighterX and Nemeth CH-47 are required to use the contents of this download. Repaints and firefighting assets by Nicholas Mitchell.

FSX/P3D Boeing E767 NATO Airborne early warning and control (AEW&C). The E767 was designed for the Japan Air Self-Defense Force. This fictional NATO version. NATO does use the E3 Sentry. This is basically the E3 radar installed on a military 767 aircraft. Includes military themed VC and revised textures. FSX Native E767 AEW&C model by TDS. Package includes military themed 737-800 VC by Alejandro Rojas Lucena/FSND/Ken Wiggington upgraded Boeing 737-800 VC model. Autobrake switch. Opening pilots window. Cabin Lights switch. Realistic FMC. Ground Proximity Warning System (GPWS). Includes added MFD and PFD panels. Exits, wheel levels, jetways and views corrected for FSX/P3d. See VC docs to get the best out of the VC and FMC. Textured and texted in P3D 5.3 by Chris Evans. Should also work in earlier P3D versions as well as FSX.

FSX/P3D Bombardier Challenger 300 Rega (air rescue) package. . Swiss air ambulance service Rega is based at Zurich and currently has 3 Bombardier Challenger 650 aircraft. This Challenger 300 is reasonably near to the 600 and was designed by Richie Schwertfeger. It's a pretty aged design but reasonable enough even today as freeware. Repainted by request from 'Vane' on the Simviation forums. Repainted by Chris Evans.

FSX/P3D ATR72-210F ASL Airlines Switzerland (Farnair) o/f DHL package. ASL Switzerland (Farnair) operates humanitarian and cargo flights from it's base at EuroAirport Basel Mulhouse, Switzerland. Model and VC by Virtualcol. Ex payware. Textured and assembled for P3Dv 5 (and should be ok in FSX and earlier P3D versions) by Chris Evans.

SP-EQF was delivered to EuroLOT in August 2012. It joined the main LOT fleet in April 2015. It carried this "Ptasie Mlecko" special scheme between April 2017 and October 2018. Ptasie Mlecko is a brand of chocolate covered mallow. It comes in a variety of flavors, in both light and dark chocolate and is delicious. Painted on a Dreamwings Dash 8-Q400, this model works in both FSX and FS2004. It may also work in P3D v3 (not 4+) although it has not been tested there. Enjoy.

Aichi D3A2 model 22 Val During the early years of the pacific war, the Val was a highly effective and feared aircraft but this gradually changed as the war progressed. When the US Navy sank the 4 of the most important Japanese aircraft carriers during the battle of Midway, many Vals and their experienced pilots were lost. Based on combat experiences, the designers from Aichi tried to improve the top speed of the D3A1 model 11 by replacing its engine with the much more powerful Kinsei 54 (take-off power: 1300 HP). This modification went into mass-production in August of 1942 as the Aichi D3A2 model 22, and was delivered to units during fall of 1942. By this point however, the new D4Y1 Judy dive bomber was already available and in mass-production. The D4Y became the standard carrier dive-bomber of the Japanese navy. The D3A2 Vals were then stationed on land-based airfields as well as on smaller carriers which the D4Y couldn’t land on because of its higher landing speed. The increase in speed compared to the D3A1 however did not prevent the D3A2 from being nothing but cannon fodder for the new US fighters like the Hellcat and Corsair. Squadrons equipped with D3A2s suffered catastrophic losses and they weren’t able to deal any significant damage to allied naval vessels anymore. At the beginning of 1944 many D3A2s were modified and sent to training units, receiving the designation D3A2-K, but the D3A2 continued in service until the end of the war mainly as a kamikaze aircraft. Production of the D3A2 was completely stopped in June 1944. In total 470 D3A1s, and 1016 D3A2s were produced. The D3A remains one of the most iconic planes ever produced by the Japanese. It sank at least 16 allied warships which makes it one of the most successful dive-bombers of all time. Using the D3A1 by Akemi as a starting reference, the D3A2 model and textures were developed by Captain Kurt. The pilot figures are Wolfi's freeware Japanese pilot .fsc source file. The prop spinning texture is by Kelticheart. The 2D panel background image is by Morton, much modified to more closely match the model VC. The gauges are by Microsoft, FDG, JWB and Martin Klein. The Bombs are by Allen. The air files are by Akemi, modified to D3A2 specs. The rear gunner and canopy opening are activated by the retract gear command.

FSX/P3D Airbus A320-200 Brussels Airlines 2022 livery package. Brussels Airlines currently has 16 Airbus A320-200 in it's fleet and now carries a new livery. Model by Project Airbus. 2020 updated VC by Speedbird77 with built in FMC by Garret Smith. Includes A320 operation manual and checklist. Airbus sounds included. Textured, assembled for P3D v5.3 by Chris Evans. Should work in FSX and other P3D

FSX/P3D Boeing 777F Lufthansa Cargo 'Cargo Human Care' livery with re-animated and revised virtual cockpit. Lufthansa Cargo currently have 11 Boeing 777 freighter aircraft. D-ALFI is painted in the Cargohumancare humanitarian livery. Model by Hiroshi Igami, Yosuke Ube with support of Posky members. Original VC by Jacob Kubique. Converted to FSX native by Zachary777. VC updates by Speedbird77 with gauges by G. Munro and Ken Wiggington. See Credits for more. Textured and assembled for P3d v5 by Chris Evans using the Skyspirit paint kit. Should also work in FSX nd previous P3D.

FSX Virgin Atlantic Airbus A350-1000 AGS-4G. Introducing the latest AGS-4th Generation ( Animated Ground Servicing ) and static display with new features and details, exclusively incorporate with the aircraft model. High Definition Textures, saved in 32 bits. Rear cargo lower hold model: Dolly / Container types. No virtual cockpit. Model design and paint by Camil Valiquette. ( CamSim )