CFS2 Blackburn B.26 Botha. The Botha was a British Reconaissance/Torpedo Plane that entered servive in May 1940. Severely underpowered, the Botha proved unsuitable for its designed role and therefore only has a 5 month operational career. It survived as a trainer until 1944. The Botha is often listed as one of the worst aircraft of all time. Credits: The model, dp and textures are by William Dickens The Flight airfile is by Peperez The Textures are freeware collected or made by W. Dickens. 2D Panel is a Freeware A-26 Panel by Paolo Kromberg Propeller Textures masterfully done by Kelticheart. 1.5MB

CFS2 Consolidated B-32 Dominator. A heavy bomber made for United States Army Air Forces during the Second World War, and has the distinction of being the last Allied aircraft to be engaged in combat during WWII. Developed in parallel with the B-29 Superfortress as a fallback design should the Superfortress prove unsuccessful, it only reached units in the Pacific during the summer of 1945, and thus saw only a very few combat operations against Japanese targets before the atomic bombs used on Hiroshima and Nagasaki ended the war. The model is by William Dickens The Flight airfile and dp are by Peperez The Textures are freeware collected or made by W. Dickens. Panel is converted from FS9 C130 panel with no listed author. 2.1MB

CFS2/FS2002/FS2004 Breguet Bre.695. Slight model changes to nose to give the breguet a more bird like nose and engine change FSDSv2.x Model, air file, Aircaft.config, Panel, Textures., Scenedb and Object_dp, by Jim Jacobson This is just a minor change to my Breguet 693. 6.1MB

CFS2 PV-2 Harpoon USN. A development of the PV-1 Ventura, the PV-2 Harpoon featured greater wing span, and the ability to carry a 4000 lb bomb load. Entering service in 1944 the Harpoon, 535 were produced and served as effective sub hunters. Some PV-2 Harpoons remained in service with allied countires as late as 1970. Original by Alphasim. 705K

CFS2 Focke-Wulf FW 187A-0 Falke. First designed in 1935 by Kurt Tank with absolutely no official requirement, the initial design performance calculations showed a potential speed of 348 mph (560 kmh) using 860 hp Daimler-Benz DB 600 engines. The initial batch of three pre-production Fw 187A-0 fighters were completed in the summer of 1939 with a rear facing radio/gunner position, and had 700 hp Jumo 210Ga engines. The armament consisted of two 0.787 in (20 mm) MG FF cannons and four 0.312 in (7.92 mm) MG 17 machine guns. The design was never adopted by the Luftwaffe and they fought the war with the arguably inferior bf110 and its successor, the Me210/410 series. The model is made by William Dickens The airfile and dp are by Christian Nölte The Textures by Willaim Dickens New Panel by Joachim Schmidt. 3.4MB

CFS2 Vultee V-11GB. The Vultee V-11 was a military version of Gerard Vultee's single-engine passenger transport V-1A, with which it shared the wing, the tail surfaces and the undercarriage. Designed as an attack bomber, it was a low-wing, all-metal design with an elongated, four-section canopy covering its two tandem-seated crew members. A dedicated attack bomber version was developed as V-11GB, and provided room for a third crew member-a cameraman cum bomb aimer who would also operate an additional retractable .30-inch machine gun placed on a trapdoor on the bottom of the aft fuselage. The wings now had a pair of .30-inch guns on each side. The estimated bombload was of 1,000 lbs. on internal racks over a range of 2,400 miles. Note to user: The trap door gun is operated by the "tailhook" command. If you hit shift+H on the keyboard the gun will deploy or retract. It will still fire regardless of its current position. Credits: The model is made by William Dickens The textures are by William Dickens The airfile and .dp are by Peperez The panel .bmp is by Phil Perrot. 846K

Polish fighter PZL P-11c for CFS2 only. Features: -Historically accurate markings -Dynamic virtual cockpit -1% AIR file -and the usual goodies Credits: AIR file by gregoryp using the 1% formula Prop bitmaps (prop.bmp and prop2.bmp) by Robert Reichert and Andrew Wai, modified by Eric MDL, panel, other textures, DP, and the rest by Eric of AOL. Custom sounds here.2MB

Polish observation aircraft LWS/RWD-14b Czapla for CFS2 only. Features: -Historically accurate markings -Panel, and all the normal CFS2 goodies Credits: AIR file/notes/checklist by FSAviator Prop bitmaps (prop.bmp and prop2.bmp) by Robert Reichert and Andrew Wai, modified by Eric MDL,other textures, DP, and the rest by Eric of AOL Panel originally by Michel Polski, modified to better fit a Czapla by FSAviator Aircraft uses stock sounds from the Zero, but a separate sound package fitting this aircraft is downloadable from here. 2.5MB

Polish PZL P-23a & b Karas (2 aircraft) for CFS2 only This package contains both the trainer/reconnaisance version (PZL P-23a), and the bomber version (PZL P-23b) Please consult the separate readme.txt files with each aircraft for more info. Eric of AOL. 3.8MB

CFS spitfire XIVc-D : see enclosed readme especially for panel. Model, flight model, moving parts, textures, mission : Paul Rebuffat original AFX : John Cooper (spitfire IX RCAF) sounds : RALPH PEGRAM. 976K